N-Com B901L User Instructions

21
13. INTERCOM
The N-Com B901 system allows communication with other N-Com systems, up to a maximum
distance of about 400 m
1
(in open field, with no obstacles). The range of the communication varies
depending on the N-Com systems used.
N.B.: The range and quality of the communication may vary significantly depending on the presence
of obstacles, weather conditions, magnetic fields.
13.1. N-Com “900” Series Intercom pairing up
Important: The procedure described below refers exclusively to the pairing up between the “900”
series N-Com systems.
 Make sure the systems are turned off;
 Put the systems in “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Configuration ”;
 On both systems, press the key “” until you reach the option “ Intercom pairing ”;
 On system A, press the key pertaining to the “pre-setting position” where you wish to save
system B.
Pairing up CHANNEL 1
Briefly press “n”.
Pairing up CHANNEL 2
Press the “n” key twice.
Pairing up CHANNEL 3
Press the “n” key three times.
The Intercom connection with the selected channel is automatically activated at the end of the pair up
procedure.
13.2. Pairing up other N-Com intercoms
Important: The procedure described here below refers exclusively to the pairing up of “900” series N-
Com systems with N-Com systems OTHER THAN the “900” series
2
.
 Make sure the systems are turned off;
 Put the N-Com system in “Setting” mode: press the “ON” key and keep it pressed for 4
seconds, until the blue LED starts to flash quickly;
 Put B901 system in “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Configuration ”;
 On B901 system, press the key “” until you reach the option “ Intercom pairing ”;
 Press the “ON” key: selection of the right pairing up mode is confirmed by a change in the
“standby” tone (high beep) and by the voice announcement “ Pairing up other N-Com
systems ”;
 On B901 system, press the key pertaining to the “pre-setting position” where you wish to
save the other N-Com system.
1
The carbon fibres used to make the X-lite helmets interfere with the transmission of the Bluetooth
radio system. Therefore, the quantity and/or position of the carbon in the helmet caused a reduction in
the communication distance that varies depending on the helmet model being used. The reduced
distance concerns all the intercom systems available on the market, built-in or not built-in.
2
Except for Bluetooth kit and Bluetooth kit2, which are not compatible.

N-Com B901L Specifications

General

Brand	N-Com
Model	B901L
Category	Motorcycle Accessories
Language	English