N-Com B901L User Instructions

EN
24
Smart Conference connection
Press the “
n
” key for 2 seconds. Activation is confirmed by a
beep in the helmet and by the voice message “ Group
Intercom” .
Smart Conference disconnection
Briefly press the “
n
” key. Disconnection is confirmed by the
voice announcement “ Group Intercom terminated ”.
N.B.: During a “ Smart Conference ” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
Note: The “ Smart Conference ” mode can be used EXCLUSIVELY with “900” series N-Com systems”.
Note: The “ Smart Conference ” mode CANNOT be used with systems paired up in Universal Intercom
mode (chapter 14.1).
14. “UNIVERSAL INTERCOM” INTERCOM
The N-Com B901 system can be connected via Bluetooth to intercom systems of other brands, thanks
to the UNIVERSAL INTERCOM function.
14.1. Pairing up the UNIVERSAL INTERCOM
The N-Com system can be paired up to the other intercom (from now on referred to as Intercom B)
as if it was a mobile phone.
1. Make sure the B901 is turned off;
2. Put the system in the “Configuration” mode: press the “ON” key and keep it pressed for 4
seconds, until you hear the voice announcement “ Configuration ”;
3. Press the pushbutton “” until you reach the option “ Universal intercom pairing ” mode.
4. Put intercom B in the mobile phone pairing up mode (refer to the Intercom B manual);
5. After a few seconds, Intercom B will emit the confirmation beep.
N.B.: The system paired up using the UNIVERSAL INTERCOM is saved in the first available channel.
14.2. Universal Intercom Function
To turn on and off the audio between two helmets, proceed as follows:
From the N-Com B901 system:
Connect or disconnect Intercom B as you would for a regular N-Com intercom (chapter 13).
Intercom B may receive a dialing one that must be answered with a phone reply command.
From intercom B
Press the “ Voice call / Dial last number called ” command.
To disconnect the intercom, press “ Hanging up/rejecting a phone call ” command.
N.B.:
 The N-Com B901 systems keeps an active connection with a mobile phone or a GPS even
during Bluetooth communication with other intercom systems.
 The intercom system connected to N-Com B901 may not allow simultaneous connection to a
mobile phone.
 Only one system paired up in Universal Intercom mode can be stored.

N-Com B901L Specifications

General

Brand	N-Com
Model	B901L
Category	Motorcycle Accessories
Language	English