To Next Page

To Previous Page

Fig. 35

ONLY FOR FLIP-UP / JET HELMETS:

 Secure the neck roll (left side), being careful to

slide the neck roll plastic ring behind the

microphone, then clicking it in the press stud. (Fig.

35)

 Secure the neck roll (right side) by hooking up the

plastic ring to the press-stud.

Warning: Always verify the proper length of your chinstrap and adjust it if necessary, referring to the

specific helmet instructions.

Warning: After the B901 is installed on the helmet, make sure the microphone is properly positioned

in front of your mouth, if necessary adjusting the moveable element.

Warning: The wind protector, supplied as standard equipment with helmets that can be opened, may

make it more difficult to open and close the chin guard when the microphone is installed.

3.8. Removing the system

To remove the system from the helmet, proceed as for the installation, by removing the various parts.

Important: to remove the keypad support, proceed as follows.

Fig. 36



Remove the keypad support from the helmet

shell (Fig. 36);



Take out the antenna from the plastic

support of the keypad (Fig. 37);

 Remov

e the Flex cable of the keypad from

the connector found on the electronic card;



Now completely remove the keypad support

from the helmet;



Bring the antenna inside the helmet, passing

it through the hole in the helmet shell. (Fig.

38).

Fig. 37

Fig. 38

The keypad support can be removed in case you decide to no longer use the system. However, it

cannot be reused again as it will have lost its adhesive properties. Contact your local dealer to

purchase a new keypad support that will stick properly to the helmet shell.

N-Com B901L User Instructions

Other manuals for N-Com B901L