N-Com B902L User Manual

7
3. INSTALLATION ON THE HELMET
Important
: Prior to installing the N-Com system, it is recommended to write down the identification
code affixed to the product (see chapter 21.4).
You can download the installation video from www.n-com.it N-Com / Download section.
• Before you install the B902L system on the helmet, make sure it turns on properly. Press the “
ON
”
key for about 2 seconds, until the blue LED on the key pad lights up and you hear a beep in the
headset. Proceed with the installation.
• Remove the cheek padding (see helmet instructions).
• Remove the helmet edge gasket using the special tool (Fig. 1).
• Completely remove the gasket as shown in Fig. 1; by doing so you also remove the padding.
• Remove the “N-Com” plugs found at the back of the shell gasket and on the left side of the
helmet.
Fig. 1 Fig. 1 – ONLY FOR N87 – N100-5 HELMET
• Prior to installing the N-Com system, remove any filling foam material, if present, from the helmet
(refer to the user manual for your specific helmet).
Option 1 Option 2
N.B.
: Keep the filling material in case you wish to use the helmet without the N-Com system in the
future.

N-Com B902L Specifications

General

Brand	N-Com
Model	B902L
Category	Motorcycle Accessories
Language	English