N-Com BX5 User Manual

EN
10
3.3. Installing the microphone – jet helmets or flip-up helmets
 Set up the microphone by inserting the clip that holds it in place, being careful to position it
correctly. (Fig. 11)
Note: The flat part of the clip has to face upward when the microphone is positioned as shown in Fig.
11.
 Position the microphone on the left side of the helmet, screwing the screw into the small frame.
(Fig.12 a/b) Make sure that the fluorescent band is facing the inside of the helmet.
 On certain helmets, the housing for the microphone rod must be created by cutting out the helmet
border gasket along the pre-cut area. (Fig. 13)
3.4. Installing the microphone – full-face helmets
 Take the polystyrene cheek pad (left-hand side) and position the microphone in its housing, as
shown in fig. 14, making sure that the fluorescent band stays facing the inside of the helmet. (Fig.
15)
 Secure the microphone to the cheek pad using the “microphone securing stickers”, see Fig. 14.
Fig. 14
Fig. 15
Fig. 11 Fig. 12a
Fig. 12b Fig. 13

N-Com BX5 Specifications

General

Brand	N-Com
Model	BX5
Category	Conference System
Language	English