EN
17
11. MUSIC VIA BLUETOOTH
To pair up an Mp3 device to the B802 system, follow the procedure illustrated in Chapter 8.
Play music (Play) Press and hold the “” key for about 2 seconds.
Pause function (Pause)
When the player is connected and playing music, press and hold
the “” key for about 2 seconds.
Next track (Skip) When the player is playing music, press “” for about 3 seconds.
Previous track (Rewind) When the player is playing music, press “” for about 3 seconds.
11.1. Sharing music via Bluetooth (A2DP Sharing)
During the intercom connection, you can start playing music by pressing and holding the “” key for
about 2 seconds. The music will be played in both systems.
Music sharing temporarily cuts off the intercom conversation; however, this can be automatically
restored by stopping the music (press and hold the “” key for about 2 seconds).
N.B.: music shared through the intercom can be managed by both systems, for example, both systems
can change the track by pressing the relevant command.
N.B.: when the “Audio Multitasking” function (chapter 13) is enabled, the “Music Sharing” function is
temporarily disabled.
N.B.: the “Music Sharing” function can only be used with the N-Com series “600”/”800”/”900”.
12. NAVIGATOR PAIR UP
B802 system is compatible with the most common satellite navigators for motorcycles. For a list of
compatible models and additional details, visit the website www.n-com.it
Make sure the B802 is turned off.
Put the system in the “Pairing up” menu: press the “ON” key and keep it pressed for 4 seconds
until you hear the voice announcement “
Pairing up Menu
”.
Press the “” key until you reach the option “
GPS Pair up
”.
Activate the search of Bluetooth devices on the navigator.
Select the N-Com system from the list. If a password is requested, enter the code 0000 (four
zeros).
After a few seconds, the connection between the two devices is activated.
N.B.: the pair up is stored by both the helmet and the navigator hence it is not lost when they are
switched off. This means that this procedure needs to be carried out only once. Once the Bluetooth
device has been paired up, connection is automatic when the system is turned on.
N.B.: intercom connection is automatically cut off every time the navigator gives directions and
restored at the end of the message from the navigator.
Should you wish to keep the navigator audio active even during the intercom connection, please
refer to chapter 13 “Audio Multitasking”.
To Next Page
Loading...
Need help?
General
