1 of 31
GT1175 Slide Door Opus Control
Wiring and Programming Manual
P/N C-00391 Rev 8-11-21
NABCO Entrances Inc. S82 W18717 Gemini Drive Muskego, Wisconsin 53150
Phone: (877) 622-2694 Fax: (888) 679-3319 www.nabcoentrances.com
NABCO hours of Operaon: Monday to Friday 8:00 a.m.- 4:30 p.m. (Central Time)
• Turn OFF all power to the Automatic Door if a Safety System is not working.
• Instruct the Owner to keep all power turned OFF until corrective action can be achieved
by a NABCO trained technician. Failure to follow these practices may result in serious
consequences.
• NEVER leave a Door operating without all Safety detection systems operational.
Table of Contents
CHAPTER 1: SAFETY ............................................................. 3
CHAPTER 2: SCOPE .............................................................. 4
SECTION 2.1: To the Installer ......................................................................4
SECTION 2.2: Objecve ...........................................................................4
SECTION 2.3: Request a User Name/Password to gain access into the “myNABCO” portal . . . . . . . . . . . . . . . . . . . . 4
SECTION 2.4: QR Code Links .......................................................................4
CHAPTER 3: GETTING STARTED .................................................... 4
SECTION 3.1: Features ............................................................................4
SECTION 3.2: Wiring ..............................................................................5
SECTION 3.3: General Specicaons .................................................................5
SECTION 3.4: Electrical Specicaons ................................................................5
SECTION 3.5: Output Power Guidelines ..............................................................5
SECTION 3.6: The Opus Control for GT1175 Units ......................................................6
SECTION 3.7: Navigate with the Rotary Dial ...........................................................6
SECTION 3.8: IO Terminal strips .....................................................................6
SECTION 3.9: Relay Output Terminal Strip ............................................................7
SECTION 3.10: CAN Bus Communicaon .............................................................7
SECTION 3.11: Simultaneous Pair ...................................................................7
CHAPTER 4: LCD CATEGORY SCREENS .............................................. 7
SECTION 4.1 Level One: Specicaon Screens ........................................................7
SECTION 4.2 Level Two: Access Screen ..............................................................8
SECTION 4.3 Enter Passcode .......................................................................8
SECTION 4.4 Cancel Passcode or Reset to Default .....................................................9
SECTION 4.5 Level Three and Four: Seng Category and Menu Items ....................................9
CHAPTER 5: STROKE LEARNING ................................................... 9
CHAPTER 6: SIMULTANEOUS PAIR ................................................ 10
SECTION 6.1: Copy Data from Type 2 (Master Control) to Type 1 (Slave Control) ...........................10
SECTION 6.2: Reseng a Type 2 Control back to a Type 1 Control .......................................11
SECTION 6.3: Customized Programming/Sengs for (1) Control only .....................................11
To Next Page
General
