Need help?Do you have a question about the NACD 11.5 and is the answer not in the manual?
General guidelines for safe working and operating practices with NACD products.
Alerts users to potential dangers from product use and emphasizes adherence to safe procedures.
Outlines the responsibility of users for following specified procedures for safe and reliable use.
Directs users to this publication for detailed information on NACD's limited warranty.
Provides necessary information for operation and maintenance of the specified NACD Power Take Off.
Details on ordering spare and replacement parts, including parts lists and bill of materials.
Information on shipping procedures, FOB terms, and responsibilities for shipping charges.
Guidance on referencing manual information for trouble-free operation and maintenance schedules.
Instructions on using lifting points and avoiding misuse to prevent damage or injury.
Emphasizes safe practices for personnel operating and servicing NACD units, disclaiming liability for injury.
Highlights dangers from product use and the need for correct procedures, guards, and safety codes.
Details on obtaining service bulletins, manuals, and contact information for NACD.
Overview of the NACD 11.5" TP Power Take-Off, its components, and lubrication.
Directs users to the warranty statement at the end of the manual for detailed warranty information.
Procedures for measuring and checking engine/motor shaft end play and run out before installation.
Steps for cleaning and mounting the drive ring onto the flywheel, including torque specifications.
Instructions for installing greasable and non-greasable pilot bearings, including sealing and lubrication.
Steps for installing the PTO onto the engine driving member, aligning shafts, and checking preload.
Tips to avoid misalignment, excessive loads, and ensure proper lubrication and clutch adjustment.
Tables providing torque values for U.S. Standard and Metric fasteners during assembly.
Data and formula for determining allowable side load pulls based on shaft speed and distance.
Guidelines for lubricating operating shaft fittings, throwout collar, main bearings, and pilot bearings.
Steps for adjusting the clutch, including initial checks and torque requirements for engagement.
Steps to remove external parts, hand lever, and the PTO housing from the engine flywheel.
Procedures for disassembling the clutch, including removing nuts, pullers, and internal components.
Steps for removing nameplates, grease fittings, bearing retainers, and bearings from the shaft and housing.
Instructions for removing snap rings, pressing sleeves, and separating bearing collars.
Steps for cleaning and installing bearing cones, cups, and retainers onto the clutch shaft and carrier.
Procedures for assembling clutch plates, center plates, floating plates, and the collar assembly.
Final assembly steps for the PTO unit, including shaft, yoke, keys, and housing components.
To Next Page
General