Need help?Do you have a question about the NAD 2155 and is the answer not in the manual?
Power Amp Specifications| continuous output power into 8Ω | 55W (17.4dBW) |
|---|---|
| rated distortion (THD 20Hz - 20kHz) | 0.03% |
| clipping power | 65W |
| IHF dynamic headroom at 8Ω | +3dB |
| IHF dynamic power at 8Ω | 100W |
| IHF dynamic power at 4Ω | 100W |
| IHF dynamic power at 2Ω | 130W |
| damping factor (ref. 8Ω, 50Hz) | >50 |
| input impedance | 22kΩ |
| input sensitivity for rated power into 8Ω | 1.3V |
| THD (20Hz - 20kHz) | <0.03% |
Bridged Mode Specifications| continuous output power into 8Ω | 125W (21dBW) |
|---|---|
| IHF dynamic headroom at 8Ω | +2.5dB |
| IHF dynamic power at 8Ω | 250W |
Physical Specifications| dimensions (W x H x D) | 420 x 108 x 380mm |
|---|---|
| net weight | 7.8kg |
| shipping weight | 9.3kg |
| power consumption | 340W |
General advice on placement, ventilation, and heat management for the amplifier.
Connects signal cables from preamplifier to amplifier inputs.
Circuit to limit distortion when the amplifier is overdriven.
Adjusts amplifier for different speaker impedances (4 or 8 ohms).
Combines two channels for increased monophonic output power.
Connects the amplifier to the AC power source.
Provides switched and unswitched power outlets for other components.
Terminals for connecting the primary stereo speaker pair.
Terminals for connecting a second pair of loudspeakers or headphones.
Button to switch the amplifier and connected accessories on or off.
Jack for connecting stereo headphones for private listening.
Lights indicating power status, protection, and soft clipping.
Buttons to select which speaker pair (A, B, or both) is active.
To Next Page
