Need help?Do you have a question about the NADAMOO Bur3069 and is the answer not in the manual?
General| Brand | NADAMOO |
|---|---|
| Model | Bur3069 |
| Category | Barcode Reader |
| Language | English |
Connect cradle to PC USB port and lift antenna. The cradle light will turn on.
Start scanner, verify lights/beeps, and charge if necessary for basic operation.
Scan a barcode into EXCEL to confirm the scanner is working correctly.
Scan specific codes to restore the scanner to its default factory settings if issues arise.
Pair a single scanner with its designated cradle for wireless communication.
Configure the scanner to transmit scanned barcodes in real-time to the connected device.
Explains how scanners act as keyboards; interpretation relies on software and correlation.
Covers issues like failed pairing, check mode, or disabled barcode types preventing reads.
Addresses discrepancies in scanned data due to specific scanner configuration settings.
Troubleshoots issues where the cradle's indicator light fails to turn on upon USB connection.
Diagnoses why the scanner shows no activity, including no beep, light, or laser.
Addresses problems where the scanner fails to retain its battery charge after charging.
Resolves issues where the scanner powers on but the scanning laser beam is absent or a mere dot.
Investigates why scanned barcodes are not transmitted to the computer despite good hardware condition.
Configures a single scanner to pair exclusively with one specific cradle.
Scans and uploads barcodes in real-time; provides feedback on success or failure.
Stores data locally when out of range, uploading automatically upon reconnection.
Stores scanned data in memory for later batch upload to the computer.
Scanner activates only when the trigger is pressed to read barcodes.
Scanner reads barcodes at a set frequency without continuous laser activation.
Scanner laser remains active, reading barcodes continuously without trigger press.
Configure the scanner to append a TAB character after each scanned barcode.
Remove the default Enter key terminator for scanned barcodes.
Append custom characters (prefix) before the scanned barcode data.
Prevent the configured prefix characters from being transmitted with the barcode data.
Append custom characters (suffix) after the scanned barcode data.
Prevent the configured suffix characters from being transmitted with the barcode data.
Remove a specified number of characters from the beginning of scanned data.
Restore previously deleted prefix characters in the scanner's configuration.
Remove a specified number of characters from the end of scanned data.
Configure the scanner to read all supported barcode symbologies.
Configure the scanner to prefix scanned data with its barcode type identifier.
Disable the transmission of barcode type identifiers with scanned data.
Configure the scanner to exclude the check digit when reading EAN-8 barcodes.
Configure the scanner to exclude the check digit when reading EAN-13 barcodes.
Configure the scanner to exclude the check digit when reading UPC-A barcodes.
Configure the scanner to exclude the check digit when reading UPC-E barcodes.
Set the scanner to convert UPC-E barcodes to their UPC-A equivalent.
Enable reading of additional digits (2 or 5) for UPC-A, UPC-E, EAN-8, and EAN-13.
Configure the scanner to include the '*' start and stop characters for Code 39.
Configure the scanner to exclude the '*' start and stop characters for Code 39.
Enable the scanner to read and transmit Code 39 barcodes using full ASCII characters.
Disable the scanner's ability to read and transmit Code 39 barcodes using full ASCII.
Configure the scanner to exclude the check digit when reading Codabar barcodes.
Set the time interval after which the scanner automatically enters sleep mode.
Choose the user interface language for the scanner's display and prompts.
Configure the volume for audible feedback, including high, medium, and low audio levels.
To Next Page
