Cradle *1 (As charging base and barcode receiver)
The scanner is powered by rechargeable polymer battery.
Please ensure that the scanner has enough power before use.
Battery level indication:
(1) Turnning the scanner on, when the buzzer beeps and the blue indicator light is on
all the time , it indicates that the battery is sufficient
(2) Turnning the scanner on, when the buzzer beeps, the red indicator light is on
or the red indicator light flash three time and then cut down automatically. Please stop
scanning and charge the scanner.
Insert one end of USB cable into the cradle, and insert another end to computer USB
interface or 5V DC USB interface power, put the scanner on the cradle, it will start
The light on scanner will turn red during charging, when the scanner is full charged, the
1. Please use computer USB interface or special 5V DC power adapter for charging, the
abnormal power will cause permanent damage to scanner and battery
To Next Page
