input level. When set to ANA, the modulometers are showing the present analog output
level.
If the CORRECTION menu is set to NONE, the brightness of the LEDS as well as
the backlight of the display is not influenced by the ambient light sources. If it is set to
AMBIENT, the less light, the lower the LED brightness and the more backlight on the
display. A sensor on the front panel detects the ambient light source.
3.2.3 REMOTE CONTROL.
The REMOTE CONTROL
menu shows the corresponding
item numbers versus the remote
control unit. The numbers
shown on this drawing corresponds to the factory settings. If needed each of them can
be individually modified.
Note that the remote control unit has a selection between minimum 1 and maximum 6.
3.2.4 POWER-UP SETTINGS.
The POWER-UP SETTINGS
menu gives the possibility to select
the way that the NAGRA-DAC will
wake up after it was in the standby
mode.
The MAIN LEVEL menu: When LAST was selected, the NAGRA DAC will wake up
with the same main level as before standby. The other possibility is to set a value
between 0 and –80 dB.
The TRIM LEVEL menu: When LAST was selected, the NAGRA DAC will wake up
with the same trim level as before standby. When RESET was selected, the NAGRA
DAC will reset all the trim values. The trim values are the actual positions of each level
and balance adjustment for all channels.
The INPUT menu: When LAST was selected, the NAGRA-DAC will wake up with the
last known input selection. Otherwise, it is possible to select a fix input between
ANALOG, SPDIF 1 to 3, TOS or AES.
3.2.5 FACTORY CONFIG.
The FACTORY CONFIG. menu permits to set the NAGRA DAC back to the
standard factory settings. In this case, everything that was stored also in the templates
will be lost. The standard factory settings are corresponding to the full menu tree in this
manual.
3.2.6 ABOUT.
To have acknowledge of the
software version and hardware
configuration, select the
ABOUT menu.
MAIN LEVEL : LAST
TRIM LEVEL : RESET
INPUT : LAST
POWER-UP SETTINGS
RESET TO DEFAULT ?FACTORY CONFIG. NO
ID MAIN : 1REMOTE CONTROL
ID TRIM : 2
ABOUT DSP SOFTWARE: V X.X
uP SOFTWARE : V X.X
To Next Page
Loading...