NAIM N-VI - Recommended Initial Setup Stages; Video System and Aspect Ratio; Colour Format and Speaker Size

E8
n-Vi
Control and Setup
6.3 Recommended Initial Setup
The n-Vi incorporates numerous features and facilities, many
of which may initially be left at their default settings until later
preferences have been established.
Six setup stages are however necessary to establish a basic
setup for satisfactory video and multi-channel audio playback of
audio and audio-visual programme material. These stages, with
their owner’s manual section numbers, are listed below. Each
is also accompanied in the body of the owner’s manual by an
exclamation mark graphic:
6.3.1 Initial Setup Stages
Stage One: Video System and Output Format
Section 7.3.1 or Section 8.1
Setting the Video System and Output Format ensures that the
n-Vi is configured correctly for the display connected. Can be
set from either the On Screen or Front Panel menus.
Note:
The default setting is auto.
Stage Two: Aspect Ratio
Section 7.3.6
Sets the video output aspect ratio appropriately for the display
connected.
Note:
The default setting is 16:9.
Stage Three: Colour Format
Section 7.4.1
Sets the video output colour format (RGB, YPbPr) appropriately
for the display connected.
Note:
The default setting is YPbPr.
Stage Four: Speaker Size
Section 7.6.1 or Section 8.2.1
Defines the size of each speaker (small, large or none)
connected to the n-Vi.
Note:
The default setting is 5.1 with large speakers.
Stage Five: Speaker Distance
Section 7.6.3 or Section 8.2.2
Defines the distance of each speaker from the listening
position.
Note:
The default setting is 0.
Stage Six: Speaker Levels
Section 7.6.5 or Section 8.2.3
Sets the relative volume level of each speaker in the system.
Note:
The default setting is 0.
!