Schedule setting method 1: user can enters into schedule on Z-Wave Set Interface, the schedule interface is
as follows:
Schedule setting method 2: on Home Interface, meanwhile the device is under Auto Mode , short press button
to enter into Auto Mode Schedule weekly setting interface quickly:
On Auto Mode Schedule weekly setting interface, use buttons and to enter into schedule setting of a certain week as
follows:
3. Manual Mode: the device will control the heating system according to current set temperature. The temperature can be
set by move up and move down button on the Home interface, or configured by Z-Wave gateway.
4.Drying Mode: The device will judge the set temperature for heating within a short period of time.
I.e.: in order to dry the water in the bathroom in a short time, the device could be set to quickly heat to dry the floor. Enter
the configuration interface as follow:
Duration: set how long the dry mode should lasts
After Mode: set the mode after the drying mode ends
Remain: shows the remaining time of the drying mode
For configuration method and modification, please refer to Automatic Mode
(Energy Save Mode) Schedule:
5.Off Mode: this mode only enables the device to turn on the heating system when anti freezing mode is enabled and the
device meets all required conditions, otherwise the device will not work, meanwhile the standby interface will only show
room temperature.
Monday-Friday
7:30,24C-12:00,20C
18:00,16C-22:30,18C
Saturday-Sunday
7:30,24C-12:00,20C
18:00,18C-22:30,18C
On Auto Day Schedule interface, short press button to select the time or temperature that you
would like to modify, then short press move up and down buttons to modify value, then short
press button to save and quit, short pressing button only quits without saving.
For each schedule, the latter time should be later than the former time, otherwise saving will fail with the error remind
“Time setting error!!!”. The default time schedules are as follows:
F
F
Short press button to select “Auto Schedule”, then short press button Schedule weekly setting interface.
F
To Next Page
Loading...
Need help?
General
