Nanit N111 - Installing Vertical Cable Covers

1716 AssemblyAssembly
A S S E M B LY///
Wipe the wall to remove dust from drilling. Then,
attach 6 cable covers to the wall straight down.
Make sure that
the male part is
oriented downwards
Feel with your fingers
and make sure the cable
is pressed into the
middle grooves under-
neath the cable cover.
Press the top first
until it clicks.
Peel o
2 tape backings
at the back of
the cable cover.
PRESS
Repeat and complete
the installation of 6 covers.
6 covers
Check that cable cover looks
straight vertically and press firmly
on to the bottom of the cover.