32
Safety Precautions
1. Please open the package to check for possible damage caused in transit, please do not use if damage is found and
contact place of purchase or manufacturer.
2. Do not use a power cord with damaged insulation, do not unplug too hard or drag the power cord directly.
3. Make sure that the power supply voltage used matches the voltage designated by the light before installation.
4. Please turn the light off when it is not in use or before cleaning.
5. Keep the light safely stored and away from children.
Notice
1. Please take off the COB protective cap before using.
2. Please do not look directly at the emitter when the light is on.
3. Please do not leave flammable or explosive articles within 0.5m of the fixture.
4. Please do not place objects on the light emitter or allow liquid to flow inside the fixture or the emitter.
5. Do not place the fixure near flammable substances like alcohol or gasoline.
6. When cleaning the light, please wipe off debris or dirt by using a cloth with clean water or neutral cleanser.
7. The fixture should be used in dry and ventilated place and avoid being used in damp, dusty or overheated
environment, also make sure the fan and the vents are not blocked or obstructed.
8. Any attempt to repair the fixture by yourself will void warranty, disasembling and repair can only be allowed when
trained professionals are involved under strict protocal regulated in this manual.
9. For optimal cooling of the fixture, the vents should not be covered when using, or might result in damaging the
equipment. The temperature on the fixture surface is high when using for a long time, please caution to prevent
burns and scalds.
To Next Page
Loading...
