NanoEnTek ADAMII-CD34 - Install SW Program

To Next Page

To Previous Page

Installation

Install

SW program

1. Turn on the PC and ADAMII

instrument.

At this time, the slide holder will be ejected automatically.

2. Double-click ‘ADAM’ icon on the PC to start the PC software.

CAUTION:

• The instrument must turn on before the PC software can run.

☞

Note: The ADAMII™ will be ready to use after initialization is completed

when powered on.

☞

Note: When the software runs and is connected with ADAMII™

normally, the state LED of instrument will be lighted up.