ht is ON. This indicates that all of your prot-
ective zones are secure. If any zones are open, the correspondin
your code, press
and re-enter the code.
3
Leave the premises through the Exit/Entry door. If the keypad gives a steady tone you have taken
too long. Enter your code again to disarm system and then re-enter code and leave.
Easy Arm
The Easy Arm feature allows the system to be armed by simply pressing
followed by
. This will
allow the easy arming of the system by someone who is not a regular system user.
Bypassing Zones
If an open zone cannot be immediately fixed it can be left unprotected, or
Bypassed
,while the rest of the
system is Armed. To Bypass a zone:
1
Press
followed by the zone number to be Bypassed. The Bypassed zone’s light will flash slowly.
2
Enter your user code. The Green Ready light will go out and the Red Armed light will light.
3
Leave the premises through the Exit/Entry door.
When the system is subsequently disarmed, all bypassed zones will be reset, ready to be armed again.
If it is necessary to bypass any inoperative zone(s), it is important to have the zone(s) repaired as soon as
possible. A bypassed zone does not provide any protection, compromising system security.
Arming Your System
6
SYSTEM
READY
ZONE 3
ZONE 1
ZONE 2
ZONE 4
ARMED
Oi220a
page 6
Tuesday, September 16, 1997 08:30
To Next Page
Loading...
Need help?
General
