Disable Exit / Entry Urgency Tone
(C)
The Urgency Tone, which changes the entry sounder to a rapid pulsating tone during the last 10 seconds of the Entry
Delay period can now be disabled.
•
To disable the Urgency Tone, add [ 2 * ] to location 2422, or Disable Exit / Entry Urgency Tone in PCD3000
Keypad Features screen.
New Relay Events
(C)
The following event has been added to the Remote Relay Control screen:
•
Fail to communicate
New Relay Event Operation
(C)
•
If Keypad Tamper Area 1 is selected it will now activate the relay for all keypads in the system.
Relay Trouble Events Change
(C)
The following Relay Events have been enhanced. In prior versions, it was required that the condition be set to ALARM in
order to activate. This had caused complications since they would also trip on General Alarms. The condition must now
be set to TROUBLE in order to trigger.
• Alarm Supervisory
• RF Receiver Trouble
•
Wireless Tamper
• Wireless Trouble
• Keypad fail
•
EZM fail
•
AC fail
• Low battery
• Fail to Open
•
Fail to Close
Pager Format Open Close Reporting
(D)
Pager format reporting in version 11C did not properly process open and close reporting. This issue has been resolved
in version 11D.
Sensor Watch Operation
(D)
Sensor Watch operation in version 11C had a problem when used in multi-area applications. This issue has also been
resolved in version 11D.
Crestron Home Automation Interface
(D)
Version 11D has been enhanced for interface to a Crestron Home Automation system. (V11D HA only).
NOTES:
(C)
Indicates features released in Version 11C Software.
To Previous Page
Loading...
Need help?
General
