R
PROGRAMMING
INSTRUCTIONS
HARDWIRE WIRELESS
GEM-X255
CONTROL PANEL/COMMUNICATOR
W1092B 9/02© Napco 2002
Quick Start:
1. Refer to the wiring diagram, connect the keypad(s), siren, aux. power, aux. output, remote bus, earth ground, zone and telephone
wiring. NOTE: See Installation Instructions (WI1093).
2. Connect AC power first and then the battery.
3. Configure the keypad (see page 52).
4. Access the Easy Menu Driven (Dealer Program) Mode:
Press
EEEEEE A
Press
NO (
g
) Until “
ACTIVATE PROGRAM Y/N
” appears on the keypad display.
Press YES (
F
) To Enter Dealer Program Mode. (see page 6 for programming guide).
Master Security Code
(on microshield)
GEM-RP1CAe2
R
COMPUTERIZED SECURITY SYSTEM
GEMINI
ARMED
STATUS
SYSTEM ARMED
01/01/97 12:00AM
12
4
3
56
7890
A
B
C
D
E
F
G
NEXT/YES
PRIOR/NO
AREA
SYSTEM ARMED
01/01/00 12:00 AM
To Next Page
Need help?
General
