2
W415-0777 / A / 04.27.10
TABLE OF CONTENTS
NOTE: Changes, other than editorial, are denoted by a vertical line in the margin.
1.0 INSTALLATION OVERVIEW 3
2.0 INTRODUCTION 4
2.1 DIMENSIONS 5
2.2 GENERAL INSTRUCTIONS 5
2.3 GENERAL INFORMATION 6
2.4 RATING PLATE INFORMATION 7
3.0 VENTING 8
3.1 VENTING LENGTHS AND COMPONENTS 8
3.2 TYPICAL VENT INSTALLATIONS 10
3.3 SPECIAL VENT INSTALLATIONS 11
3.3.1 PERISCOPE TERMINATION 11
3.4 MINIMUM AIR TERMINAL LOCATION CLEARANCES 12
3.5 VENT APPLICATION FLOW CHART 13
3.6 DEFINITIONS 13
3.7 ELBOW VENT LENGTH VALUES 13
3.8 HORIZONTAL TERMINATION 14
3.9 VERTICAL TERMINATION 16
4.0 INSTALLATION 18
4.1 WALL AND CEILING PROTECTION 18
4.1.1 HORIZONTAL INSTALLATION 19
4.1.2 VERTICAL INSTALLATION 20
4.2 USING FLEXIBLE VENT COMPONENTS 20
4.2.1 HORIZONTAL AIR TERMINAL INSTALLATION 21
4.2.2 VERTICAL AIR TERMINAL INSTALLATION 22
4.2.3 VENT CONNECTION 23
4.3 USING RIGID VENT COMPONENTS 23
4.3.1 HORIZONTAL AIR TERMINAL INSTALLATION 23
4.3.2 EXTENDED HORIZONTAL AIR TERMINAL INSTALLATION 24
4.3.3 VERTICAL AIR TERMINAL INSTALLATION 24
4.4 MOBILE HOME INSTALLATION 25
4.5 GAS INSTALLATION 26
4.6 OPTIONAL WALL SWITCH INSTALLATION 26
5.0 FRAMING 27
5.1 MINIMUM CLEARANCE TO COMBUSTIBLES 29
5.2 MINIMUM ENCLOSURE CLEARANCES 30
5.3 MINIMUM MANTEL CLEARANCES 31
5.4 NAILING TAB INSTALLATION 31
6.0 FINISHING 32
6.1 DOOR REMOVAL / INSTALLATION 32
6.2 L42 LOUVRE INSTALLATION 33
6.3 PORCELAIN REFLECTIVE PANELS 33
6.4 GRATE INSTALLATION 33
6.5 LOG PLACEMENT 34
6.6 GLOWING EMBERS 35
6.7 CHARCOAL EMBERS 35
6.8 VERMICULITE 35
6.9 CHARCOAL LUMPS 35
6.10 LOGO PLACEMENT 35
7.0 OPTIONAL BLOWER INSTALLATION 36
8.0 OPERATION 38
9.0 ADJUSTMENTS 39
9.1 PILOT BURNER ADJUSTMENT 39
9.2 VENTURI ADJUSTMENT 39
9.2 FLAME CHARACTERISTICS 40
9.3 RESTRICTING VERTICAL VENTS 40
10.0 MAINTENANCE 41
10.1 CARE OF GLASS 41
10.2 GLASS / DOOR REPLACEMENT 42
11.0 REPLACEMENTS 43
12.0 TROUBLE SHOOTING 46
13.0 WARRANTY 48
14.0 SERVICE HISTORY 49
To Next Page
