48
Specifi-
cations
ESM-30 only: Data recorder
Save interval:
The time between consecutive saves of
recorded data can be set between 1 second
and 3 minutes using the ESM-TS Interface
Set.
Data set:
The r.m.s., maximum and minimum values are
calculated continuously during the selected
save interval (the interval between
measurements is 5 ms, all data are referred to
the relevant permitted power flux density in
the same way as the displayed value).
The data for the E-field and H-field are saved
in the data recorder as a data set with a
timestamp at the end of each save interval.
Data block:
All data sets recorded between switching on
and switching off the ESM-30 “RadMan XT”
are combined into a data block. Several data
blocks can be stored in the data recorder at
any one time. These data blocks are accessed
by the ESM-TS Interface Set for evaluation.
Accessing the data using ESM-TS may result
in a brief interruption in the data recording. If
this happens, the current data block will be
closed and a new data block started after the
interruption.
Specifications
To Next Page
Loading...
