• Other functions of the ON/OFF pushbutton (held down for less than 1 second)
First press, adjustment of pre-selection time. Yellow LED flashes.
Second press, adjustment of switching-on time. Yellow LED is on.
Third press, adjustment of target temperature.
Green LED flashes.
Fourth press, display returns to measured temperature.
2. Adjusting times and temperatures
• Adjusted with +/- pushbuttons when the desired function is displayed.
3. Light in sauna room
• Light is switched on and off by pressing the pushbutton.
4.2 Signal lights
4. Green light = light on in sauna room
5. Green light = on when measured temperature is displayed.
Flashes when target temperature is displayed.
6. Yellow light = on when switching-on time is displayed.
Flashes when pre-selection time is displayed.
7. Red light = on until target temperature is reached for the first time.
4.3 Error messages
• ERR1= a break in the sensor circuit
• ERR2= a short-circuit in the sensor
circuit
• ERR3= a break in the overheat
protector’s current circuit
NOTE! If an error message
is displayed, switch off
the sauna stove.
5. TECHNICAL DATA
5.1 Upper board
• enclosure class IPX4
• the control unit can be
installed in the sauna or
in the dressing room
6. LOADING OF STONES
- When loading the stones, make sure they do not bend the resistors or obstruct
sufficient circulation of air.
- Do not load the stones too tightly. Over-filling of the stone compartment will
cause overheating of the resistors (= shorter service life) and slower heating up
of the sauna.
- Suitable stones for the stove are 4-7 cm in diameter.
- The stones shall cover the heating resistors completely.
AN UNDER-FILLED STONE COMPARTMENT WILL CAUSE A FIRE HAZARD!
ALWAYS CHECK THE SAUNA BEFORE SWITCHING ON THE STOVE.
4.4 Technical data of control unit
• Temperature adjustment
range 40ºC-120ºC
• Temperature display 20ºC-120ºC
• In increments of 1ºC
• Pre-selection time max. 24 h
• In increments of 1/2 h
• Max. Power On time 4 h
5.2 Lower board
• voltage 400 V 3N 50 Hz
• current 16 A
• stove wattage max. 9 kW
• sauna light max. 100 W
• enclosure class IPX4
• overheat protection 144ºC
• Fuse 1 1A
Fuse 2 1A
To Next Page
