Narvon 378NSSM2 - ASSEMBLY AND RINSING; Three Sink Method and Reassembly

13
NARVON SUMMIT
ASSEMBLY & RINSING
CLEANING
*
A
ssem
bl
e
mi
x
e
r
In
s
er
t
t
h
e
m
i
x
e
r
a
n
d
ro
t
at
e
t
i
ll
h
e
a
d
(
A
)
h
oo
ks
w
i
t
h
s
e
a
l
(
B
)
.
*
Ch
e
c
k
if
t
h
e
g
as
k
e
t
i
s
i
t
s
p
l
a
c
e
i
f
y
o
u
d
i
s
a
s
b
l
e
d
i
t
t
o
cl
e
a
n
.
Assemble drip
tray and air lter.
Clean the lter
weekly.
Slide the bowl back onto the unit and gently
push down until it hooks into place.
Assemble lid.
Assemble and lubricate the bowl gasket.
Lubricate the bowl hooks and the tap
seal wall.
Rinse:
Fill bowl
with water.
Mix mode
for 5
minutes.
Empty
bowl.
Place the mixer seal on the unit, then insert
the mixer and rotate until the head (A) hooks
with the seal (B).
LUBRICANT
Assemble the tap: Place the tap back on the
hooks and click into place.
1. To properly carry out the three sink method:
- Fill one basin with a neutral cleaning detergent mixed in lukewarm water.
- Leave one basin empty for rinsing
- Fill a third basin with sanitizing solution mixed in lukewarm water.
2. In the rst basin, Thoroughly wash all components in the mild cleaning detergent with a soft cloth or sponge.
3. Rinse all components in water
4. After rinsing, use a soft cloth or sponge to wipe down all of the components in the sanitizing solution, before rinsing
for a nal time