Narvon 378NSSM2 - CLEANING PROCEDURES; Disassembly and Emptying Bowls; Component Cleaning Methods

12
NARVON SUMMIT
EMPTY BOWLS
DISASSEMBLE
CLEANING
It is recommended that the machine be cleaned daily. Cleaning must be performed by a qualied operator. While cleaning the
machine, wear proper protective equipment (goggles, gloves, etc.).
Use the tap lever to empty any
remaining liquid into a container.
DO NOT proceed without emptying
the bowl.
CLEANING
The machine must be turned OFF and unplugged from the power source before cleaning.
CAUTION
Remove lid.
Remove tap:
Press (1)
and pull
upwards (2).
Clean the lid and evaporators with a mild
detergent and a soft cloth or sponge. Rinse
with water.
Remove the bowl by gently lifting the front
until it unhooks. Then, pull the rear off of
the unit.
Thoroughly wash all other components using
the three sink method.
Extract the bowl gasket and mixer. Gently remove the mixer seal.
Put the
machine in
stop mode.
Extract drip tray
and air lter.
Clean the lter
with a soft, dry
brush.
Place the components on a clean surface
to dry.