NASHONE MTS300 - Page 12

4. Push the SET/OK buon.The hour blinks.
5. Set the hour using RND/+ or CD/-.Push and hold
either buon to toggle through more quickly.
6. Push the SET/OK buon.The minute blinks.
7. Set the minute using RND/+ or CD/-. Push and hold
either buon to toggle through more quickly.
8. Push the SET/OK buon.The second blinks.
9. Set the second using RND/+ or CD/-.Push and hold
either buon to toggle through more quickly.
10. Push the SET/OK buon.
11. Switching program 1(PROG 1 ON) is set.
It will automacally back to program switch mode.
12. Push and hold the SET/OK buon and push
the RND/+ buon repeatedly. The display shows
the symbols PROG and OFF as well as the
switching program number 1.
10. Program the switch-off me by following the steps
for seng the switch-on me.
11. If required, set all 20 programs in the same way.
For examples, we set as below:
PROG 1 ON,MO-SA,14:48:35
PROG 1 OFF,MO-SA,18:22:57
12