National Instruments FieldPoint FP-1000 - Figure 2-2. Installing the FP-1000;1001 Network Module Onto a DIN Rail; Figure 2-3. Locking the FP-1000;1001 Network Module Onto a DIN Rail

Chapter 2 Hardware Installation and Configuration
FieldPoint FP-1000/1001 User Manual 2-2
© National Instruments Corporation
Figure 2-2. Installing the FP-1000/1001 Network Module onto a DIN Rail
3. Slide the network module to the desired position on the DIN rail. After
the module is in position, push the rail clip into the locked position to
lock the module in place on the DIN rail, as shown in Figure2-3.
Figure 2-3. Locking the FP-1000/1001 Network Module onto a DIN Rail
After the network module is installed, connect the terminal base to the
network module as explained in the next section,
Connecting Terminal
Bases with DIN Rail Mounting
.
Press
DIN Rail
Local Bus
Connector
Network
Module
Rail Clip
Locked
Rail Clip Unlocked
(Position Module Along DIN Rail)
DIN
Rail