National Instruments FieldPoint FP-1000 - Appendix A Specifications

© National Instruments Corporation A-1 FieldPoint FP-1000/1001 User Manual
Appendix
A
Specifications
This appendix describes the specifications of the FP-1000 and FP-1001
network modules.
All FieldPoint network modules undergo extensive testing for operating
under rugged environmental conditions that exist in industrial
applications. FieldPoint network modules are designed and tested for
immunity and susceptibility, as well as for emissions.
Network
FP-1000..............................................1 RS-232 port, 1 RS-485
repeaterport
FP-1001..............................................1 RS-485 port
Baud Rates..........................................300, 1200, 2400, 9600, 19200,
38400, 57600, 115200
(switch-settable)
Communication Parameters................1 start bit, 8 data bits, 1 stop bit,
no parity
Integrity..............................................Checksum
Cabling Distance from Host*
FP-1000.....................................50 ft. (nominal)*
FP-1001.....................................4000 ft. (nominal)*
* Refer to the
RS-232 Interface Specifications
and
RS-485 Interface
Specifications
sections in Chapter2,
Hardware Installation and
Configuration
.
Power Supply Range...........................11 to 30 VDC
Power Consumption............................1 watt + 1.15 * ∑(
I/O Module
Consumption
)
Maximum Terminal Bases per Bank...9