Chapter 2 Hardware Installation and Configuration
©
National Instruments Corporation 2-17 FieldPoint FP-1000/1001 User Manual
Completed Hardware Installation
When power is applied, the ACCESS and STATUS LEDs should flash
once, and the POWER LED should stay lit. The POWER and READY
LEDs should be lit on all of the I/O modules. If these LEDs are not lit,
check your power connections and make sure that all of your modules
and terminal bases are firmly mated. If the STATUS LED is blinking,
refer to Table3-2,
STATUS LED Flashes and Corresponding Error
Conditions
, in Chapter3,
Feature Set Description.
To Next Page
Loading...