National Instruments FieldPoint FP-1000 - Page 55

Chapter 4 Installing and Using the FieldPoint Software
© National Instruments Corporation 4-17 FieldPoint FP-1000/1001 User Manual
at the slowest rate of the Advises. The loop may not execute at all if any of
the Advises is set to complete “On Data Change”, and the data of the
corresponding I/O Item never changed.
4. Use FP Close to close the server. This action also stops all pending
Advise operations.
Note: This example reads the value of an I/O Item value from the FieldPoint
device. To write to an Output Item, use FP Write instead of FP Advise (or
FP Read).
Figure 4-8. LabVIEW Diagram for LabVIEW Example Application