National Instruments FieldPoint FP-1000 - Page 66

FieldPoint Banks
Please use one page per FieldPoint bank.
Network module _____________________________________ Firmware revision ____________
Address __________________________________________ Baud rate ___________________
Circle the state of the following items when your problem occurs:
LEDs POWER: ON/OFF
NETWORK: ON/OFF ACCESS: ON/OFF STATUS: ON/OFF
SnapShot feature Enabled/Disabled
Watchdog timer Enabled/Disabled Timeout value _______ ms
Number of FieldPoint terminal bases ________________________________________________
Number of FieldPoint I/O modules __________________________________________________
Base
#
Module Name*
POWER
LED
READY
LED
Module Configuration Information
0 FP-1000/1001 ON/OFF ON/OFF
1 ON/OFF ON/OFF
2 ON/OFF ON/OFF
3 ON/OFF ON/OFF
4 ON/OFF ON/OFF
5 ON/OFF ON/OFF
6 ON/OFF ON/OFF
7 ON/OFF ON/OFF
8 ON/OFF ON/OFF
9 ON/OFF ON/OFF
* If a terminal base is present but no module is inserted, write “none.”