Note Power on V
SUP
is required for transceiver cable
operation.
Note When using more than four transceiver cables
with your CompactRIO chassis, refer to the NI-XNET
CAN/LIN Transceiver Cables page on ni.com for
mounting guidelines to limit the thermal impact to your
CompactRIO system.
The following figure shows the NI 9860 with Port 1 connected to
an NI-XNET CAN HS/FD Transceiver Cable and the
two-position connector connected to the power cable. The breaks
in the cables represent additional cable length.
6 | ni.com | NI 9860 Getting Started Guide
To Next Page
Loading...
