Table 6. NI-Digital Pattern Driver Example Locations (Continued)
Application
Software or
Application
Development
Environment (ADE)
Location
LabVIEW Use the NI Example Finder to locate LabVIEW examples. In
LabVIEW, select Help»Find Examples to launch the NI Example
Finder.
Microsoft Visual
Studio
The Microsoft .NET examples are located in the <Public
Documents>\National Instruments\NI-Digital
\Examples\DotNET 4.x directory. In the Start menu, navigate to
NI Digital Pattern Examples in the National Instruments folder.
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit ni.com/support.
What Should I Do if the PXIe-6570 Doesn't Appear in
MAX?
1. In the MAX configuration tree, expand Devices and Interfaces.
2. Expand the Chassis tree to see the list of installed hardware, and press <F5> to refresh
the list.
3. If the module is still not listed, power off the system, ensure that all hardware is correctly
installed, and restart the system.
4. Navigate to the Device Manager.
Operating System Description
Windows 10 Right-click the Start button, and select Device Manager.
Windows 7 Select Start»Control Panel»Device Manager.
5. If you are using a PXI or PXI Express controller, verify that a National Instruments
entry appears in the System Devices list. Reinstall NI-Digital Pattern Driver and the
module if error conditions appear in the list. If you are using an MXI controller, right-
click PCI-to-PCI Bridge, and select Properties from the shortcut menu to verify that the
bridge is enabled.
What Should I Do if the Module Fails the Self-Test?
1. Restart the system.
2. Launch MAX, and perform the self-test again.
PXIe-6570 Getting Started Guide | © National Instruments | 13
To Next Page
Loading...
