Type Menu
Value
Mode Menu
Value
Range Value Number Step / Wrap
Inc Min / Max
(0-127)
Step (-128 to
127) / Wrap
Program
Change
Toggle / Gate Off / On
(0-127)
Trigger 0 - 127
Inc Min / Max
(0-127)
Step (-128 to
127) / Wrap
Mode Menu Values for Pedals (Switch)
For the button-like control elements listed in the above table, and only for some of the MIDI
message types available for these control elements, you can choose from different behaviors
for the way the data is sent. This is controlled by the Mode menu. This menu can have up to
four entries, depending on the message type that you have selected in the Type menu. Here is
the list of all possible entries:
▪ Toggle: In this mode, the control element has two states, On and Off. If you press once, it
switches to the On state — if you press again, it switches to the Off state. This can be use-
ful for example for activating some effect, then deactivating it later. This is usually the de-
fault mode. In this mode, you find two numeric fields: Off Value defines the value for the
Off state (from 0 to 127, 0 by default), and On Value defines the value for the On state (0
to 127, 127 by default). For the Note message type, since the Off state is predefined (it’s
the MIDI Note Off message), you find instead a single Value parameter defining the veloci-
ty of the MIDI Note On message.
▪ Gate: This mode is equal to Toggle with the difference that the state is active for the time
the Pedal is hold depressed. In Toggle mode the state is activated until the next time the
Pedal is pressed again.
▪ Trigger: In this mode, only one message is sent when you hit the control element. There are
no On or Off states. For example, this can be useful for switching to another program (pre-
set, patch…) or for triggering one-shot samples (e.g. drum sounds or any other envelope-
MIDI Communication
Using the MIDI Assignment Editor
KOMPLETE KONTROL - Manual - 96
To Next Page
Loading...
Need help?
General
