12 ALGO® 5 Newborn Hearing Screener Service Manual
P/N 000995 Rev.A
5. Install the Keyboard
• Unpack the keyboard and set aside. Pull the top drawer all the way out from beneath
the writing surface to reveal the front of the cart column.
• The DSP mounting bracket must be temporarily moved to provide access for routing
the printer cable to the Panel PC (see FIGURE 17). Using the 1/8” allen wrench,
unscrew the two lower set screws that hold the mounting bracket to the cart column,
slide the bracket up by about 3”, and tighten the screws to hold the bracket in place.
FIGURE 17: Access for routing the printer cable
• Place the keyboard on the top drawer. Route the keyboard cable out through the
hole behind the tray that holds the keyboard and up through the cable routing guide
on the cart column (FIGURE 18). Plug the keyboard cable into the Panel PC to any
of the available USB ports on the bottom (FIGURE 20).
FIGURE 18: Routing the keyboard cable
Slide
Up
To Next Page
Loading...
