natus ALGO 5 - Page 14

14 ALGO® 5 Newborn Hearing Screener Service Manual
P/N 000995 Rev.A
FIGURE 20: Panel PC Interface
• Return the keyboard tray and the top drawer to their original positions. Loosen the
screws that secure the DSP mounting bracket, slide the bracket back down to its
original position, and tighten BOTH screws to ensure ground contact (FIGURE 17).
6. Install the DSP Box
• Unpack the DSP Box. Remove the four screws provided in the bag attached to the
DSP mounting bracket. Position the DSP Box so that the power receptacle (black
cable in FIGURE 21) faces the left side of the cart as viewed from the front. Install
the four screws to secure the DSP Box to the mounting bracket.
Power Connection
DSP Box – COM
Port 1
Scanne
r
Ke
y
board
Full Size Printe
r
Label Printe
r