Nautilus Bowflex SelectTech Stand - Page 6

6
2. Remove and Discard the Rubber Stabilizers, and then Attach the Dumbbell Bases
Remove the dumbbell from its base before you attach the Dumbbell Base to the stand to make sure that the dumbbell does not
fall during installation.
Fully tighten the hardware before you put the dumbbells into the installed Dumbbell Bases on the stand.
Note: The Rubber Stabilizers and hardware must be removed from the Dumbbell Bases and discarded. The 560 Dumbbell Base is not
included with the Stand.
#2
J
K
X8
X8
#2
Dumbbell Bases
#2
J
K
X8
X8
#2
Dumbbell Bases