Connect to Lowrance Displays | 61
Communications Port menu (left). Radar Notice (right) prompting users to leave radar in Standby Mode
for 30 minutes when activating radar for the first time.
Caution: Leave the radar in Standby Mode for 30 minutes when activating it the first time. This
will help maximize the life of the magnetron. After the radar has been activated the first time,
ignore the Radar Notice.
To access Radar Page:
• Press Pages, then use to select the radar tab.
• Press to select
Radar Only
then press Exit.
Radar only highlighted on Radar Pages menu (left). Radar menu with Radar Power selected (right).
• Press Menu, then use to select
Radar Power
from the radar menu and press Ent. A
confirmation message will appear. Press to select Yes and press Ent. A warm-up
countdown will commence that will vary depending on the model of radar you have.
• After the countdown is finished, the unit will enter STANDBY mode.
• Access the Radar Setup menu to make sure your radar display is set to Heading Up and is
set to a Full Color scheme. Press Menu, select
Radar Setup
and press Ent.
To Next Page
Loading...
Need help?
General
