89Installation Checklist
PCB DIP SW 2 setting (Set of 8) Ye s N o
Is switch #1 set correctly for the gas type used? (NG-OFF, LP-ON)
If continuous boiler operation is required, is switch #7 in the up (ON) position?
If high temperature venting has been installed (CPVC or polypropylene), is switch #8 in the up (ON) position?
Operating the boiler Ye s N o
Have you given the Installation & Operation Manual and User’s Information Manual to the owner for future reference?
Have you shown the owner how to shut off the gas in case of an emergency?
To Next Page
Loading...
Need help?
General
