Why is the water not hot enough in my Navien Water Heater?
If the hot water is not hot enough, first check the water heater's temperature setting. Also, check for cross plumbing between the cold and hot water lines.
What to do if the water from my Navien Water Heater faucet is cold?
If the water from your hot water faucet is cold, try these steps: First, clean the cold water inlet filter. Then, fully open the hot water faucet. If an error code is displayed, refer to “5.2 Understanding Error Codes” on page 17.
Why is the water too hot from my Navien Water Heater?
If the water is too hot, check the water heater’s temperature setting.
How do I troubleshoot error code E109 on a Navien NPE-240S2?
If you see error code E109, clean the intake air filter.
Why does it take so long for hot water to reach my Navien NPE-240S2 Water Heater fixtures?
If it takes too long for hot water to reach the fixtures, have a contractor install a circulation return line from the farthest faucet back to the water heater.
How to fix Navien NPE-240S2 error code E016?
If you see error code E016, try these steps: Clean the cold water inlet filter and flush the heat exchanger.
How to resolve Navien Water Heater error code E030?
If you see error code E030, try these steps: Clean the cold water inlet filter and flush the heat exchanger.
How to fix Navien NPE-240S2 Water Heater error E004?
If you see error code E004, make sure the electrical cord is properly grounded.
What to do if no water comes out of my Navien NPE-240S2?
If no water comes out when you open the hot water tap, make sure the shut-off valves on the hot and cold pipes are open. If an error code is displayed, refer to “5.2 Understanding Error Codes” on page 17.
What to do if Navien NPE-240S2 displays error code E438?
If you see error code E438, check if the circulation pump is working correctly.
Explains DANGER, WARNING, and CAUTION symbols and their implications for user safety.
Essential safety guidelines for initial operation, gas leaks, and electrical safety protocols.
Addresses scalding hazards, temperature settings, and the use of mixing valves.
Procedures for safely changing the hot water temperature.
A chart to diagnose and resolve basic issues like no hot water or insufficient heat.
Explanation of error codes displayed on the panel and their remedies.
General| Type | Tankless |
|---|---|
| Fuel Type | Natural Gas or Propane |
| Energy Factor | 0.96 |
| Water Connection Location | Bottom |
| Voltage | 120 V |
| Water Connection Size | 3/4 inch NPT |
| Gas Connection | 3/4 inch NPT |
| Venting | PVC, CPVC |
| Warranty | 15 years heat exchanger, 5 years parts |
| Maximum Input | 199, 900 BTU/h |
| Flow Rate | 0.5 GPM (activation) |
To Next Page
