Navistar INTERNATIONAL DT 570 - Entering Vehicle Information Using the EST

5 HARD START AND NO START DIAGNOSTICS 149
2. Do the following procedure “Entering Vehicle
Information using the EST” to complete the rest
of the form heading:
Entering Vehicle Information using the EST
Figure 170 American Trucking Association
(ATA) connector
Figure 171 EZ-Tech® interface cable
Figure 172 EZ-Tech® interface cable
WARNING: To avoid serious personal injury,
possible death or damage to the engine or
vehicle, read all safety instructions in the “Safety
Information” section of this manual.
1. Connect the EZ-Tech® interface cable to the EST
and the ATA connector.
2. Boot-up EST.
Figure 173 International® launchpad
3. Select Engine Diagnostics, then International®
MasterDiagnostics® II.
EGES-270-1
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
Follow all warnings, cautions, and notes.
©August 2008 Navistar, Inc.