INSTALLATION/ SERVICE MANUAL
10
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS
• #3 Phillips screwdriver
• 10, 11, & 13mm wrench
• Socket driver w/ extension
• Wire cutters
• Assorted socket set
• Safety glasses
• Flashlight (optional)
REQUIRED TOOLS & PARTS
Disconnect all batteries before beginning
installation. If the car has a Run/Tow switch, you
must place the switch in the TOW position rst!
CAUTION
PURCHASED PARTS
• Controller w/ Bluetooth
• Mounting Plate w/ hardware
• On-The-Fly Programmer
ALL 6 mm Bolt 60 in-lbs/ 5 ft-lbs/ 6.8 Nm
Battery 5/16 Thread 90 in-lbs
To Next Page
Loading...
Need help?
General
