NAVITUS MCL 5.10 User Manual

19
2. Wireless “in”
configuration
0. RETURN
Back to the main menu
1. Request to proceed timeout
During the specified time the received
request has to be send to a meter (through
RS485/RS232 out), if it times out the
request will be discarded
2. Byte w. timeout in X bytes
Timeout value defined in byte transfer time
(it depends on baud rate) multiplied by this
setting value. Timeout is set after each
received byte in frame. If timeout expires
after last received byte, the frame is
accepted. This setting is for RS485 out
interfaces
3. Idle timeout
Idle timeout period in seconds
4. Connection check period
Time after which the controller tries to
communicate with GSM network to test
conectivity
5. Signal indication level 1-2
LED signal level indication settings
6. Signal indication level 2-3
LED signal level indication settings
7. Enable time sync with
provider
Enable time sync with provider
8. Minimum tolerated signal
level
Tolerated signal level. If the signal level is
weaker than the minimum level, the
controller will change the connection to 2G
9. Grant menu interface
This option allows to enable or disable the
menu through the interface specified
3. RS232 IN
configuration
0. RETURN
Back to the main menu
1. Request to proceed timeout
During the specified time the received
request has to be send to a meter (through
RS485/RS232 out), if it times out the
request will be discarded
2. Data rate
RS232 IN baud rate configuration
3. Data bits
Define data bit quantity
4. Stop bits
Define stop bit
5. Parity
Define parity
6. Byte wait timeout
Timeout value defined in byte transfer time
(it depends on baud rate) multiplied by this
setting value. Timeout is set after each
received byte in frame. If timeout expires
after last received byte, the frame is
accepted. This setting is for RS485 out
interfaces
7. Answer wait timeout
Time for waiting data (answer) in RS485
out, after the request has been sent
8. Grant menu interface
This option allows to enable or disable the
menu through the interface specified
4. RS485 OUT
configuration
0. RETURN
Back to the main menu
1. Request to proceed timeout
During the specified time the received
request has to be send to a meter (through
RS485/RS232 out), if it times out the
request will be discarded
2. Data rate
RS485S out baud rate configuration
3. Data bits
Define data bit quantity
4. Stop bits
Define stop bit
5. Parity
Define parity
6. Byte wait timeout
Timeout value defined in byte transfer time
(it depends on baud rate) multiplied by this
setting value. Timeout is set after each
received byte in frame. If timeout expires
after last received byte, the frame is

NAVITUS MCL 5.10 Specifications

General

Brand	NAVITUS
Model	MCL 5.10
Category	Controller
Language	English