Page 12 Naxa Electronics
Programming a Playlist
When the CD is stopped, you can select up to 20 CD or
MP3 tracks to play in any order that you choose.
1. Press the STOP key [2] to make sure that playback
has stopped.
2. Press the PROG/+10 key [3]. The LED screen [12] will
ash “01” and the Program indicator [9] will ash.
3. Use the REW or FF keys [4, 6] to choose a track to
enter into the playlist.
4. Press the PROG/+10 key [3] to save the track into
the playlist. The LED screen [12] will then ash the
next playlist track number (e.g., “02”).
5. Repeat steps 3 and 4 until your playlist is complete.
You can save up to 20 tracks.
6. Press the PLAY key [5]. Play will start from the rst
track in the playlist and the Program indicator [9]
will ash. Play will stop once all of the programmed
tracks have been played.
7. Press the STOP key [2] to stop the programmed
playlist, then press the STOP key [2] a second time
to clear the playlist from Program memory.
⚠L
Opening the CD compartment [11] will clear
the playlist from Program memory.
You can replay a playlist at any time as long
as it has not been cleared from memory yet.
To do so, press the PROG/+10 key [3] while
play is stopped, then press the PLAY key [5].
If you want to edit the existing playlist:
1) Press the STOP key [2] once to stop
playback; 2) Press the PROG/+10 key [3]
to enter program mode; 3) The player will
review and display on the LED screen [12]
all of the existing tracks of the playlist
in order; 4) When the LED screen [12] will
ashes “01,” use the REW or FF keys [4, 6]
to select the program number that you
want to edit, then press the PROG/+10 key
[3]; Use the REW or FF keys [4, 6] to select
the track you want to save, then press the
PROG key [3].
To Next Page
Loading...
