45
Planar-D1 / Compact-M2 R7
DE
EN
IT
Malfunction and remedy
n WARNING
Risk of injury or damage to property.
`
Work must not be continued with a faulty NBB radio control system!
`
Always contact your dealer or NBB in the event of a fault.
`
Only allow repair work to be carried out by a specialist.
Error Possible cause and remedy
No response
when switched on
The transmitter is switched on.
→ Check whether the transmitter is switched on.
The receiver is not connected to the power supply.
→ Check the power supply of the receiver.
The wrong frequency channel is set.
→ Check or change the current frequency channel (optional).
Individual commands
are not executed
A control element on the transmitter is defective.
→ Have the control element repaired by an authorised specialist workshop.
The output control on the receiver is defective.
→ Have the output control repaired by an authorised specialist workshop.
The machine control is defective, e.g. the cable from the receiver to the device
to be controlled (transmitter and receiver are OK).
→ Have the defective parts repaired or replaced by an authorised specialist workshop.
Customised locking is not released.
→ There are various options/causes here, e.g. dead man's joystick.
Maintenance and care
n CAUTION
Risk of injury or damage to property.
The system to be controlled becomes incapable of action for a certain period of time.
`
Disconnect the receiver from the power supply during electric welding work
on the machine, otherwise there is a risk of damage to the receiver electronics.
`
Only allow repair work to be carried out by a specialist.
Your NBB transmitter is maintenance-free. Nevertheless observe the following points:
– Remove building material residues and other dirt from the receiver.
– Check the receiver for damage.