NCR RealScan 7872 Installation/Owner Guide
497-0415291 Release F 08/04 13 of 44
Hole Requirements for Cables
When you run the various cables through the checkstand, you might have to drill holes
in some of the panels. The holes must be large enough for the connector on one end of
the cable to pass through. You must also ensure that there are no sharp edges to cut the
cable. The following table gives the minimum hole size for each of the RealScan 7872
cables.
Cable Cable Length Minimum Hole Size
Power Cord ñ Outlet to
Power Supply
3.05 meters (10 feet) 3.18 centimeters (3/4 inch)
Power Cord ñ Power
Supply to RealScan 7872
1.22 meters (4 feet) 1.52 centimeters (1/2 inch)
Interface Cable 8.0 meters (26.24 feet) 1.90 centimeters (3/4 inch)
4.0 meters (12.12 feet) 1.90 centimeters (3/4 inch)
Remote Display Cable 8.0 meters (26.24 feet) 1.90 centimeters (3/4 inch)
4.0 meters (12.12 feet) 1.90 centimeters (3/4 inch)
To Next Page
Loading...
