Cleaning Mode
Neato XV™ Series User Guide 21
Cleaning Mode
Your Neato cleans using its powerful vacuum. Just press the START button and it will
vacuum your home, cleaning one room at a time. Neato creates a map of your home as
it goes from room to room. When it needs to recharge its batteries, it uses the map to
find it way back to where it started. Depending on where it started, it will:
START Connected to Charge Base: If Neato started at its charge base, it will
return to the charge base to recharge, and after charging, go out and continue
cleaning where it left off. If it still hasn’t finished cleaning, it will return to its
charge base once more, recharge, and return to finish cleaning where it left off.
START Not Connected to Charge Base: If Neato did not start at its charge base, it
will go back to the location where it started, stop, and say please recharge my
battery. When finished charging, place Neato within two feet of where it stopped
and press START. It will return to where it left off to finish the cleaning job. This
can be repeated one more time if it hasn’t finished the cleaning job.
During a cleaning cycle Neato will do a maximum of three cleaning runs. When Neato
finishes a cleaning cycle the map is erased.
To Next Page
Loading...
Need help?
General
