The HDMI port and USB port cannot be used to simultaneously stream video and audio content.
Important Safety Instructions
Due to the enclosure material, the product must only be connected to a USB 2.0 or higher.
The adapter should be installed near the equipment and must be easily accessible.
Do not use the device in an environment where the temperature is too high or too low. Never expose the device
to strong sunshine or wet environments.
The ideal temperature range for this product and its accessories is 41 °F – 95°F / 5°C – 35°C.
When charging, place the device in an environment with a temperature that ranges between 41 °F – 77°F / 5°C
– 25°C as well as good ventilation.
Only use the charger provided by the manufacturer. Using unauthorized chargers may cause danger and
violate the projector’s guarantee.
This charger is for indoor use only.
The charger type is HKA 1807 9095-6C with output voltage/ current of DC19V/9.47A. The plug of the adapter is
considered as the disconnect device. Once unplugged, the charger is considered as disconnected from the
power source.
Possibly hazardous optical radiation emitted from this product, do not stare at operating beam. Maybe harmful
to the eyes.
Notice
This product complies with the radio interference requirements of the European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited. declares that this device is in compliance with the essential requirements and
other relevant provisions of Directive 2014/53/EU. For the Declaration of Conformity, visit the website:
uk.seenebula.com.
RF exposure information for D21 50: The Maximum Permissible Exposure (MPE) level has been calculated based on
To Next Page
Loading...
