DT710(ITL‐2E)
QuickUserGuide
forDT710phonescontrolledby
SIP@Net
Fordetailedinformationpleaseconsult
thecomprehensiveUserGuideavailable
at:www.nec‐unified.com.
©NECUnifiedSolutions2010
Allrightsarereserved.Reproductioninwholeorinpartisprohibited
withoutthewrittenconsentofthecopyrightowner.
Allbrandnamesandproductnamesinthisdocumentaretrademarks
orregisteredtrademarksoftheirrespectivecompanies.
PLACINGCALLS
1. Liftthehandset,presstheSpeakerkey,orpress
theprogrammableLinekeytoreceivedialtone.
2. Enterthetelephonenumberoftherequired
party.
3. Waitafewsecondsforthecalltobe
automaticallydialed.
4. Whenthedialedpartyanswers,usetheheadset
orMICtostarttheconversation.
USINGPHONEFEATUREKEYS
1. Hold–Placescurrentcallonhold.Toresumethe
heldcall,presstheHoldkey.
2. Transfer–Initiates/completesatransfer.
3. Speaker–Full‐duplexspeakerphonecapability.
4. Recall–RefertoHold.
5. Feature–Thiskeydisplaysasetofmenuoptions
thatprovideadditionalcapabilities.
6. Redial–Dialsthemostrecentlydialednumber
again.
7. Conf–Initiates/completesaconference.
8. Answer–WhentheLED(15)isON,pressthekey
toanswerawaitingcall.
9. Mic–Pressthiskeytomutethemicrophone:
theLEDisflashing.Pressthekeyagaintoun‐
mutethemicrophone.
10. Directory–OpensthePersonalDirectory.
11. Message–Automaticallydialstopickupvoice
messages.
12. S Up/ T Downkeys–Usetoadjustthebasic
settingsonthephone.
13. LineKey–owntelephonenumber.
14. SpeedDialKey–Automaticallydialsanumberor
(de‐)activatesafunction.
BASICSETTINGS
Toadjusthandsetvolume
Presstheup/down S T keyintheoffhookstatus
orduringacall.
Toadjustspeakervolume
Presstheup/down S T keyduringspeakerphone
operation,orduringacallthatisbeingplayedonthe
speaker.
Toadjustringtonevolume
Presstheup/down S T keyduringringing.
Issue:May2010 DT710(ITL‐2E)QuickUserGuide 1