FEATURE
The feature key is used to activate terminal setup functions
and to program one-touch speed dial keys. By depressing
FEATURE plus a number, your terminal will perform specific
activities.
FEATURE + 1 = Turns microphone on or off.
FEATURE + 2 = Adjusts handset receiver volume
FEATURE + 3 = Selects ringer tone
FEATURE + 4 = Adjusts transmission/receiving volume
FEATURE + 5 = Activates hands-free operation
FEATURE + 6 = Deactivates hands-free operation.
FEATURE + 7 = Turns call indicator lamp on or off for in
coming call notification.
HOLD
To place a call on HOLD:
1. Depress the HOLD button once.
2. Replace the handset in the cradle.
Calls may not be left on Hold for longer than approximately 2
minutes. The NEAX is programmed to "remind" you that
there is a call on hold and will return the call to you with a
series of short, steady rings.
To retrieve a call placed on HOLD:
1. Lift the handset.
2. Depress the "held" line key.
HOLD, EXCLUSIVE
Exclusive Hold enables you to place a call on hold and
prevent other stations with that line appearance from
retrieving the call. The call can be retrieved only from the
station that placed it on hold.
FWD-NA: (Forward No Answer) This feature, when
activated (or set), forwards incoming calls to the destination
assigned by the user when the terminal is left unanswered
after 3 rings.
To activate any of the Forward features:
1. Depress the SPEAKER key or lift the handset.
2. Depress the FWD line key you choose to activate
3. At the tone, enter the forward destination number (FWD
Set will appear on the LCD).
4. Depress the SPEAKER key or return the handset to the
cradle (The LED will light indicating the feature has been
activated).
To cancel any Forward feature:
1. Depress the SPEAKER key or lift the handset.
2. Depress the activated FWD line key (FWD CNCL will
appear on the LCD).
3. Depress the SPEAKER key or return the handset to the
cradle.
Note: Any combination of forwarding features can be used,
however, FWD-All (Forward All) will override the other two
forward features.
SPEED DIAL
You can store numbers (up to 24 digits) of your choice and
reprogram them as often as you please. The numbers
remain stored in memory until you reprogram them. Any
unused line appearance key may be used as a user defined
speed dial key.
To program SPEED DIAL numbers:
1. Depress the FEATURE key.
To Next Page
Loading...
Need help?
General
